Cement and plaster mixtures can be cast in the mold regardless of the type of rubber the mold is made of. Any special requirements, as resin and wax, has to be specified when placing the order.

The recommended and guaranteed release agent is DISARMING-F2 (which can be purchased at our office), which can be used pure or diluted up to 20% with water. Alternatively, you can use a mixture of soap and water (like Castile soap) to 50 and 50%. Other types of release agents can be discussed over the order’s submission.

The mold’s standard locking device consists of through bolts of different sizes. Other types of locking devices can be supplied under request depending on the budget (hooks, hinges, clamps plates etc.).

Different solutions can be provided under request and depending on the budget, such as manual overturning systems, support plates, frame bolts, reinforced counterparts etc

Yes, the counter-molds can be modified in thickness or implemented with different

reinforcement materials and closures.

Fiberglass counter molds are always replaceable and repaired. The rubber must be

evaluated at the time, depending on the type of model or deterioration.

To get a quote for an item that is not in our catalogs is enough to send a picture or a drawing of the model that you want to make, along with as many information as possible (height, width, depth, type of material etc.). If you don’t have a model, but you only have a drawing (or even just a concept), you can still get a model made by our sculptors.

To ensure consistent effectiveness over time, the mold needs few but important care:
-Keep the mold away from direct sunlight or heat sources;
-After and before each cast clean any spilled material and cleanse the mold;
-During storage, carefully close the mold into the fiberglass counterparts ensuring that the joints are properly lined up, spread the inside with a coat of industrial talcum powder and protect the outer rubber parts from direct sunlight or heat sources.

We manufacture molds under request; the manufacturing lead time for a single item from our catalog is 5-7 working days. In the case of multiple items the manufacturing lead time will depend on the the amount of items (maximum 30/40 working days). The timing will always be discussed when the order is submitted.

The goods will be sold ex-factory, so you can come and pick up the molds directly from our warehouse or our couriers can deliver them to you everywhere in the world, once you accepted the shipping costs